CyberResearch UCERB 24 Manual de usuario descargar pdf (Pagina 15)

UCERB 08 User's Guide Installing the UCERB 08

Connecting the external power supply

Power to the UCERB 08 is provided with the 9 V, 1 A external power supply . You must

connect the external power supply before connecting the USB connector to the UCERB 08.

To connect the power supply to your UCERB 08, do the following:

Connect the external power cord to the power connector labeled

POWER IN on the UCERB 08

enclosure (PWR IN on the board). Refer to for the location of this connector. Figure 3-1

Plug the AC adapter into a power outlet.

The

PWR LED illuminates green when 9 V power is supplied to the UCERB 08. If the voltage supply is

less than 6.0 V or more than 12.5 V, the PWR LED does not light.

Do not connect external power to the POWER OUT connector

The power connector labeled POWER OUT on the enclosure (PWR OUT on the board) is used to provide

power to an additional CyberResearch USB DIO product. If you connect the external power supply to the

POWER OUT connector, the UCERB 08 does not receive power, and the PWR LED will not illuminate.

Connecting the UCERB 08 to your system

To connect the UCERB 08 to your system, turn your computer on, and connect the USB cable to a USB

port on your computer or to an external USB hub that is connected to your computer. The USB cable

provides communication to the UCERB 08.

When you connect the UCERB 08 for the first time, a

Found New Hardware popup balloon (Windows

XP) or dialog (other Windows versions) opens as the UCERB 08 is detected.

When this balloon or dialog closes, the installation is complete. The USB LED should flash and then

remain lit. This indicates that communication is established between the UCERB 08 and your computer.

If you are running Windows XP and connect the UCERB 08 to a USB 1.1 port, a balloon displays the

message "

Your USB device can perform faster if you connect to a USB 2.0 port." You can ignore this

message. The UCERB 08 will function properly when connected to a USB 1.1 port.

Caution! Do not disconnect any device from the USB bus while the computer is communicating with

the UCERB 08, or you may lose data and/or your ability to communicate with the UCERB

08.

If the LED turns off

If the LED is lit but then turns off, the computer has lost communication with the UCERB 08. To

restore communication, disconnect the USB cable from the computer, and then reconnect it. This should

restore communication, and the LED should turn back on.

2-4

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 29 30

Sin comentarios

CyberResearch UCERB 24 Manual de usuario Pagina 15