CyberResearch UCERB 24 Manual de usuario descargar pdf (Pagina 14)

UCERB 08 User's Guide Installing the UCERB 08

No function

Configures relays 5-8

Configures relays 1-4

Figure 2-2. Typical board switch

Port CL consists of relays 1 through 4, and Port CH consists of relays 5 through 8.

Remove from the enclosure to access the on-board switches

To change the configuration of a switch, you must first remove the UCERB 08 from the enclosure.

Relay control logic parity

Configure the

Invert/non-invert switch (S1) to set the relay control logic polarity for each relay bank for

invert or non-invert. By default, this switch is shipped with all banks configured for non-inverted logic, as

shown in . Figure 2-3

Figure 2-3. Invert/non-invert switch S1

NON-INVERTINVERT

PULL UPPULL DOWN

 NON-INVERT mode: when "0" is written or read back via the USB bus, the relays are not energized.



INVERT mode: when "0" is written or read back via the USB bus, the relays are energized.

Switch settings for polarity can be read back via software through the USB bus. Switch settings for S1 do

not affect the power-on condition.

Relay power-on state

Configure the

Pull-up/pull-down switch (S2) to set the state of each relay bank at power-up. By default,

this product is shipped with the switch for all banks configured for pull-down (relays inactive at power

up), as shown in . Figure 2-4

Figure 2-4. Pull-up/pull-down switch S2

When set to pull-up, the relays are put into an energized state at power-up, regardless of the state of

switch S1. When set to pull-down, the relays are put into a non-energized state at power-up.

Switch settings can be read back via software through the USB bus.

2-3

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 29 30

Sin comentarios

CyberResearch UCERB 24 Manual de usuario Pagina 14