CyberResearch UCERB 24 Manual de usuario descargar pdf (Pagina 13)

UCERB 08 User's Guide Installing the UCERB 08

Unpacking the UCERB 08

As with any electronic device, you should take care while handling to avoid damage from static

electricity. Before removing the UCERB 08 from its packaging, ground yourself using a wrist strap or

by simply touching the computer chassis or other grounded object to eliminate any stored static charge.

If your UCERB 08 is damaged, notify CyberResearch, Inc. immediately by phone,

fax, or e-mail.

 Phone: 203-483-8815

 Fax: 203-483-9024 to the attention of Tech Support

 Email: techsupport@cyberresearch.com

Installing the software

Installing the software is very basic: insert software CD and follow prompts on screen.

Installing the UCERB 08

Board label Description Default

setting

INVERT NON-INVERT

Configures the relay control logic parity per relay bank for invert or

non-invert logic.

Non-invert

Pull DOWN PULL UP

Configures the relay power-on state per relay bank for pull-up or

pull-down.

Pull down

Each DIP switch sets the configuration of one relay group. The switch labeled CL configures relays 1

through 4, the switch labeled

CH configures relays 5 through 8.

2-2

The UCERB 08 has two on-board switches that you set to configure the relay logic polarity and the

resistor pull-up/down configuration. Configure these switches before you connect the4 external power

supply to the UCERB 08. Factory-configured default settings are listed in the table below. Refer to Figure 3-1

for the location of each switch on the UCERB 08.

Configuring the hardware switches

The UCERB 08 has two on-board switches that you set to configure the relay control logic polarity and

relay power-on state. Factory-configured defalut settings are listed in Table 2-1. Refer to Figure 3-1 for the

location of each switch on the UCERB 08.

Table 2-1. Default switch configuration

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 29 30

Sin comentarios

CyberResearch UCERB 24 Manual de usuario Pagina 13